- General purpose pick hammer
- Test Light
- Toe Dolly
- Heel dolly
- Scratch awl
- Baseboard sander 17” Hookit (plastic or fiberglass handle)
- Rubber sanding block (5”x2 ¾”)
- Razor blade scraper
- Seven piece door tool set-Tools to remove trim pads,
fender skirts, door handles, plastic bumper covers
- ¼
” drive, 44-piece socket set-standard and metric, shallow
and deep well
- 3/8” drive, 51-piece socket set-standard and metric, shallow
and deep well
- Combination 3/8” to 1” wrenches-11-piece
- Putty knife
- Blowgun (air blower), NIOSH approved
- Wire brush
- 1- line-up punch or bar (approximately 18” long)
- Cold chisel ½” cut
- Light dinging spoon
- Adaptor 3/8 F to ¼ M
- Center punch (7” long)
- Adjustable joint pliers 8” (Arc joint)
- 10 CR vice grip
- Ballpeen hammer (32 ounce)
- One 25-ft. tape measure with metric/English
- 1 Torx bit 3/8 drive (T-50)
- One 7” needle nose pliers with side cutter
- Small drill index 1/16”-3/8” with coated drills (21
piece)
- Combination metric wrenches 8-19 mm, 10-piece
- Ratcheting magnetic screwdriver set with Torx (T-10),
(T-15), (T-20), (T-25), (T-(T-40), and 2 Phillips and 2
straight bits
- Screw driver set-6-piece combination Phillips and flat
tips
- Magnetic pick-up tool
- Small pocket light (Stylus 3) 4A batteries
- Safety glasses
|
